aa-fords.com

1929 AA Express Parts Build – Price – Make Offer or $7,900 – No title – Location: Boulder, CO Contact – aafords.com@gmail.com This is a collection of parts assembled onto a 1929 AA chassis. Parts have been bolted onto the chassis for photographing. Detailed information and many photographs are at ht...

FYI - part A-4520-C was outer u-joint housing assembly. So, this assembly consisted of both the upper and lower parts. Also, A-4520-C assembly was used for both the AA and A.

A 29 AA would have a worm drive rear axle. Wheel bolts are swedged to the drum /hub. New hubs and or drums are not being made for AA trucks.

The dual high transmission was a Ford assembly line option. The shifter pedal is seen above the floor board (see attached drawing).

Ford shows a drawing date of May 7,1930 for the long wheel base frame and the Chicago Service Letter of June13, 1930 mention the long wheel base frame. Drawing date is not production date. In May of 30 they were still producing the Early 1930 model that carried over the 1929 sheet metal and was onl...

Chris Haynes wrote: ↑

March 16th, 2024, 4:16 pm

Bob C wrote: ↑

March 16th, 2024, 8:08 am

"The 1930 didn't have a rigid front mount either."

The long wheel base tapered frame had a solid front engine mount until December 1930.

The long wheelbase came out in '31.

The long wheelbase came out in 1930. It had a tapered frame and had a solid front crossmember.

macswoods wrote: ↑

February 26th, 2024, 9:10 am

looking for a front spring for my 29 AA. and need the information on the dimensions of the spring. thanks Mac...

Look at https://aafords.com/aa-chassis/aa-5310- ... 1927-1929/

I need to see a picture of what he is talking about. Chris, I can't find a photo of these small tubular spacers which keep the rear engine mount bolts nuts from compressing the rubber cushions. I found the A-chassis part number in a Steve Plucker document. The AA spacers were slightly longer due to...

The rear motor mount spacer is 19/32" long. What is the OD and ID? Is there any reason not to use a solid steel vs the original split steel spacer? THANKS jmcpherson, I don't find the information you requested (sorry). The ID will need to be large enough to allow the bolt to slide through (not...

A vehicle's wheelbase is the measurement from the center of the front wheels to the center of the rear wheels. Ford offered a 131 and 1/2 inch wheelbase for the full production period. Starting mid 1930, Ford offered a 157-in wheelbase. There was also a 112 inch wheelbase which was a stand drive cha...

The top is the driver side and the bottom is the drinkers side. The drinkers side has never been replaced but the drivers side was and maybe they quit after that one. Confusing, I thought the driver/drinker side were one in the same. :( Parts price list Aug. 1, 1929 A-2060-B Front brake grease baff...

Still looking for a buyer.

OK, I think I will go ahead with Warford install in my AA project. I believe it’s a 28-29 style but I think I have the correct u-joints to make it work along with the splined rear bracket for cross member. I have all new bearings but will need to have a new counter shaft made. My next hurdle will b...

Chris Haynes wrote: ↑

October 18th, 2023, 9:48 pm

I was hacked last Saturday. That email was sent to everyone in my computer. I did not send it.

Thanks for the update Chris. I'm in

Chris, FMAATC is getting unusual email from your email address. I think you have been hacked. Are you sending me email requesting I purchase an Apple Gift Card for you?