Search found 4 matches
- February 14th, 2021, 7:00 am
- Forum: AA Ford Discussion
- Topic: Pictures of the Inside of a Bevel Gear Drive
- Replies: 7
- Views: 5365
Re: Pictures of the Inside of a Bevel Gear Drive
Thanks for taking the time to post this set of photos.
- May 1st, 2020, 10:00 am
- Forum: AA Ford Discussion
- Topic: AA FRONT END LARGE DIAMETER KING PINS
- Replies: 5
- Views: 5347
Re: AA FRONT END LARGE DIAMETER KING PINS
Thank you David and Bob for your assistance. I purchased a set of bearings from Grainger and they are a good fit and should work fine. The shell configuration is a bit different from the original and they are a ball instead of a roller bearing. I also purchased the three bearings that were posted on...
- April 27th, 2020, 7:29 pm
- Forum: AA Ford Discussion
- Topic: AA FRONT END LARGE DIAMETER KING PINS
- Replies: 5
- Views: 5347
AA FRONT END LARGE DIAMETER KING PINS
I'm looking to learn about the transition from .812 diameters front spindle king pins, bushings and thrust washers to 1.00 diameter. Was that done at a certain date in the AA production or was it dependent on some other factors? These are stamped FORD BB but I'm assuming they were used on the AA as ...
- April 27th, 2020, 1:41 pm
- Forum: AA Buy and Sell
- Topic: Wanted: King Pin Set for 1930 AA
- Replies: 3
- Views: 5394
Re: Wanted: King Pin Set for 1930 AA
Just read this successful sourcing of Large Diameter King Pins. Could someone give me a quick lesson on when the AA King Pins switched over from .812 diameter pins to 1.00" diameter pins and associated bushings. Also looking for a source for the larger diameter thrust bearings and bushings. I h...