Search found 5 matches

by rugb
February 19th, 2019, 7:53 am
Forum: AA Ford Discussion
Topic: AA piston ring question
Replies: 1
Views: 620

AA piston ring question

I’m rebuilding an engine for a ‘29 AA Ford and running into something maybe someone else has?? Bored to .100 over and am finish honing to fit the pistons. Don’t have rings yet so going to order them. What I am finding out is the ring grooves aren’t as deep as the original pistons. These are .166” an...
by rugb
January 5th, 2012, 7:32 pm
Forum: AA Ford Discussion
Topic: '29 AA Front wheel grease seal
Replies: 2
Views: 1163

'29 AA Front wheel grease seal

This may have been bought up before, but my question is, is there a seal/slinger/retainer used to hold the grease in on the front inside bearing? Reassembling mine today, I seem to not have that part (been apart too long) Ordered them for an A axle but too small. And does someone sell what I need? T...
by rugb
February 10th, 2011, 11:15 am
Forum: AA Ford Discussion
Topic: Brake linkage shaft, rear on a '29
Replies: 3
Views: 604

Brake linkage shaft, rear on a '29

These parts are from a '29 AA that I am restoring. Does someone have the answer as to how snug this shaft should fit into the hole it goes into? As you can see there is quite a bit of wear and plan to get the shaft built up and hole bushed or sleeved. Or is there supposed to be a bushing in there or...
by rugb
September 7th, 2009, 7:02 pm
Forum: AA Ford Discussion
Topic: Drag link question?
Replies: 2
Views: 684

Drag link question?

Just a simple question.... Is the drag link on a '29 AA Truck supposed to be straight? Mine that I am restoring has a couple slight bends in it. Looks useable, but just wanted to know if I should get it back to straight or leave the bends in it. Thanks
by rugb
January 12th, 2009, 8:03 pm
Forum: AA Ford Discussion
Topic: Rear axle seals for my 29 AA
Replies: 4
Views: 1743

Re: Rear axle seals for my 29 AA

Hopefully this works to send along these pictures of a tool I made to install the rear axle seals in a '29 AA rear axle. I am working on restoring this truck and needed to get the seals in. Hunting around the shop, I found these bearing parts and a little grinding and cutting and they worked fine fo...