aa-fords.com

I'm working on my ignition wiring and have plenty diagrams to go from. The only thing I cannot find is what gauge wire to use, as nobody seems to put these on their drawings. I want to do these: Red wire from ignition switch to coil. Black wire from coil to junction box. Yellow from junction box to ...

I went to a taller castle nut, which covers more of the thread and torqued it to almost 100 FP.
I will drive this truck sometime in the near future.
Marty

Has anyone installed a battery disconnect switch?
From what I've read, it should be installed on the ground side.
I would like to know what anyone has done and how it worked out.
Thanks,
Marty

The threads are mostly worn off. I will meet with a tool maker tomorrow and see if he can cut them down to 14mm x 1.5.
Man I sure don't want to take the rearend out again.
Marty

My spindle threads are almost not there.
I'm trying to find what I can do, without taking it all apart to replace them.
Can I have the threads built up and threaded or cut down and threaded using a smaller castle nut?
What else might I think about before rushing into something wrong?
Marty

Check Coker Tire, they have many tires and the larger tire you are looking for.
Marty

My lever has not been bumped.
I will remove the assy and have a look at it and sweeten it up, I'm sure it could use it.
Thanks,
Marty

OK, this should be easy to figure out; but I keep trying to find the reason my gas peddle sticks. It drives find until I stop and the engine is running faster than normal, then I have to pump the peddle to back it down. I've oiled and greased all points and it remains the same. What am I missing? Ma...

Wow I wish my firetruck looked that good. Keep up the good work.
Marty

Sure sounds like the float is set too high. It is easy to remove and take apart and check. You may need to rebuild using new parts.
Marty

It sounds like a broken gear.
I've had the same noise only in 1st gear.
Good luck with it.
Marty

I want to install seat belts in my truck. All I've found do not have Ford logo on the buckel. Anybody know where I might find any with Ford on them?
Marty

Shelby
I have a 28 pickup roadster and could use your doors.
It was a good write up and I thank you.
Marty

Fred:
I've been on vacation and so am just now getting back to my computer.
If you want to put it on the site, that's ok with me.
Marty

My email is:
captain_marty@att.net