Search found 1322 matches

by Bob C
November 11th, 2019, 8:52 am
Forum: AA Ford Discussion
Topic: INTERMEDIATE SHAFT GEAR BACK LASH TOLERANCE
Replies: 2
Views: 806

Re: INTERMEDIATE SHAFT GEAR BACK LASH TOLERANCE

Is this what you are asking about? There's one on Ebay, not cheap. https://www.ebay.com/itm/1929-1930-1931 ... DX&vxp=mtr

Bob
AA4811.jpg
AA4811.jpg (161.27 KiB) Viewed 769 times
by Bob C
November 10th, 2019, 8:43 am
Forum: AA Ford Discussion
Topic: Drive Shaft Repair
Replies: 3
Views: 916

Re: Drive Shaft Repair

I would use #4 or #6.

Bob
by Bob C
November 4th, 2019, 8:24 am
Forum: AA Ford Discussion
Topic: starter dirve lubrication or not?
Replies: 2
Views: 944

Re: starter dirve lubrication or not?

I would would try light oil or graphite spray but not grease.

Bob
by Bob C
November 3rd, 2019, 4:26 pm
Forum: AA Ford Discussion
Topic: Truck progress photos
Replies: 57
Views: 21615

Re: Truck progress photos

Looks great. See page 442 of the Service Bulletins for instructions on adjusting the reverse lockout.

Bob
by Bob C
November 1st, 2019, 5:10 pm
Forum: AA Ford Discussion
Topic: Battery amps required
Replies: 2
Views: 838

Re: Battery amps required

Specifications show 80 ampere hours for Model A and Model AA.

Bob
by Bob C
October 28th, 2019, 6:53 pm
Forum: AA Ford Discussion
Topic: Brake Drums
Replies: 10
Views: 1711

Re: Brake Drums

Those numbers are for Model A's I think AA's would be thicker.

Bob
by Bob C
October 27th, 2019, 7:02 pm
Forum: AA Buy and Sell
Topic: 30-31 high speed rear axle
Replies: 2
Views: 1658

30-31 high speed rear axle

Saw this on Craigslist, not mine. https://westslope.craigslist.org/pts/d/ ... 62074.html

Bob
by Bob C
October 25th, 2019, 8:10 am
Forum: AA Ford Discussion
Topic: AA-17287 Thrust Washer (speedometer driving gear)
Replies: 2
Views: 862

Re: AA-17287 Thrust Washer (speedometer driving gear)

The MAFFI site shows the drawing date of 5/13/1929.
by Bob C
October 23rd, 2019, 7:14 pm
Forum: AA Ford Discussion
Topic: Torque Tube Grease Retainer (seal) Dimension?
Replies: 12
Views: 1976

Re: Torque Tube Grease Retainer (seal) Dimension?

I have noticed quite a few new seals are thinner than the old leather ones.

Bob
by Bob C
October 23rd, 2019, 9:37 am
Forum: AA Ford Discussion
Topic: Torque Tube Grease Retainer (seal) Dimension?
Replies: 12
Views: 1976

Re: Torque Tube Grease Retainer (seal) Dimension?

Neil, I don't have an original seal handy but my seal interchange book shows 1.250 ID, 1.987 OD and .437 W.

Bob
by Bob C
October 22nd, 2019, 9:38 am
Forum: AA Ford Discussion
Topic: Torque Tube Grease Retainer (seal) Dimension?
Replies: 12
Views: 1976

Re: Torque Tube Grease Retainer (seal) Dimension?

Neil, isn't the drive shaft seal AA-4686? AA-4245-D is the seal that goes at the end of the axle housing.
The picture is AA-4245-D.

Bob
DCP_0909.JPG
DCP_0909.JPG (24.84 KiB) Viewed 1880 times
by Bob C
October 14th, 2019, 1:23 pm
Forum: AA Ford Discussion
Topic: Steering worm removal.
Replies: 20
Views: 3500

Re: Steering worm removal.

See pages 318 and 363 of the Service Bulletins.

Bob
by Bob C
October 13th, 2019, 8:53 am
Forum: AA Ford Discussion
Topic: King pins
Replies: 3
Views: 1136

Re: King pins

Good question, pretty sure they can be installed either on top or on the bottom (I think I've done both) but as you say the correct position is on the bottom on a double A which would move the spindle up would it not? I don't think the spindle locking pin will allow the bearing to be installed eithe...
by Bob C
September 29th, 2019, 8:56 am
Forum: AA Ford Discussion
Topic: Original AA colors
Replies: 20
Views: 3503

Re: Original AA colors

On my monitor that looks like Pegex Orange, Vermilion is a red.

Bob
by Bob C
September 28th, 2019, 11:06 am
Forum: AA Ford Discussion
Topic: Original AA colors
Replies: 20
Views: 3503

Re: Original AA colors

The Paint & Finish Guide shows Rock Moss Green, Blue Rock Green and Black. After September 1930 the following colors were added
Phoenix Brown, Menelous Orange, Rubelite Red, Pegex Orange, Copra Drab, and Thorne Brown.

Bob