aa-fords.com

I saw this on craig's list. give it a look.

http://nh.craigslist.org/pts/2541547083.html

Hey,
I have two budd wheels, I live in mass. Interested in making the trade?

I just downloaded the PDF that explains that the rubber kit I have which is for the original mounts , should not be used with the float a motor mount system where the mount bolts to the inner frame. So I understand then the bolts will line up, but shouldn't I put something there to prevent metal on ...

My rubber kit came with two pieces of rubber an inner, which is L shaped. Then metal spacers and an outer rubber which is just flat.

While restoring my engine, I took a look at the motor mounts and took them off to be cleaned and painted. I read alot about the vibration that transfers about the frame, so I looked into the two piece mounts sold at mac's, design looks good but bolt pattern only lines up without rubber against the s...

Hey, thanks. I saw it before but forgot about it. No savings going local. Thanks.

I had my 4 speed transmission housing brazed up and leak tested, it is all set to go. Before I go and put the parts back, I was thinking of replacing the open bearings with sealed bearings. I don't want to come back in here again for a while. Can I buy these locally, Napa, Etc, or am I relegated to ...

Does anyone have a picture.

I know that the two head bolts where the water inlet port are 5+ inches and the rest might be 3 15/32. On mine I have one that is 3 3/4, 2 that are 5+ and the rest are 3 15/32. Is this correct or is that a rouge bolt put in there? The engine is not complete so I don't know what that long bolt should...

Hey, I think I have what you need, and I live in MA. 5 hole?

Found one thanks

Hi,
I am looking for an emergency brake cross member shaft for my 29 AA. Any and all sources welcome. Thanks

Perfect, that's exactlywhat I need. Thank you!!!

I have some five spokes wheels. Shipping would be tough. I can grab a picture if you want.

Hi, my truck is missing the cross shaft, so if someone could snap a picture from the rear facing the cross shaft, so i can get a clean look at it, it would really help.