aa-fords.com

Does anyone have one of the springs that they would like to sell? Dimensions are OD. .920 ID..740 length 1.50 coil dia. .091.

Thanks for the info , I will check online and see if I can find one.

Hi does anyone have dimensions of the spring that goes in the front of the intermediate shaft? Looking for OD and ID and overall length. My truck was dismantled when I got it the spring is amongst the missing. I have the cone shaped nut that screws into rear of transmission, but the spring is missin...

I am in process of putting rebuilt engine in my AA everything was going well until got to installing pressure plate and disc. Repair manual say distance to release fingers on pressure plate should be between 5/8 and 3/4 of a inch. When I install mine I get about 1 and 3/16 of a inch. I have several ...

Thanks Neil your the best, that picture is a big help. thanks again.

Hi Neil if you could post pic. here that would be great.

thanks for taking the time to take pic, they answer a lot of my questions. i have printed them and will use them as reference.
Neil i will try and start a tread in disscusion forum.

Hello crosscut, I am trying to put together a express bed 1930-31 truck. I bought a repo bed and I was planing on modifying coupe fenders. Could you take a couple of measurements from the fender you have for sale? Dimension from running board edge (inside dimension) to rear edge (inside dimension) a...

I am looking for a repairable AA radiator, does any one have one they would like to sell?

Does anyone have a set of these longer rear spring assemblies they would like to sell? Or are there drawings that would give original dimensions? Looking for something that might give a little softer ride?

Thanks Neil thats what I had when I pulled it a part.

Hi Neil it is a mid 1930 to 31 AA , sorry I should have included that.

Rebuilding the front end on my AA , does anyone know if the AA had the cup washer and felt around kingpin like the model A front ends. Cant seem to find any good info in any of the books that I have. Also I have the brake cross shaft out and the bronze bearings are worn out. The new bearings are off...

I HAVE THE BEVELED GEAR REAR END WHERE DO i get the service bulletines?

I have Jim Schilds book , looking for repair info on rear ends.