torque on the rear axle nut.
Posted: May 21st, 2009, 8:28 pm
A mid year 30 truck. Has the bango jug.
1. Other then damn tight, is there a torque on these nuts prior to inserting the cotter pin?
2. A. What about the pivet point nut. Just tight enough to insert the cotter pin?
B. How much side to side play, if any, be allowed?
1. Other then damn tight, is there a torque on these nuts prior to inserting the cotter pin?
2. A. What about the pivet point nut. Just tight enough to insert the cotter pin?
B. How much side to side play, if any, be allowed?