If the old lock rings on the wheels are badly pitted or dented, are there new ones available or what does one do? I took a wheel to a few tire places and they wouldn't even let me take it out of my truck. Scarry! I got it apart ok and got the new flap, tube and tire installed with no problem. I aired up the tire with the lock ring facing the ground to about 15-20 pounds and then tapped around the ring with a rubber hammer to make sure the ring was well seated before inflating to full pressure. Anybody got a better idea on dealing with these wheels?
Thanks,
Big A with a '30 wrecker to be
wheel lock rings?
-
- Posts: 92
- Joined: January 16th, 2003, 2:45 pm
- Body Type: 82A Cab 89A Express
- Model Year: 1929
Lock Rings
Howdy,
I'm not that far along with my truck yet, but I've heard others asking the same question.
One suggestion was to use a couple of pieces of heavy chain. Run the chain through the openings in the rim, around the tire and ring, and fasten together with a bolt. I'd use a grade 8 bolt.
These chains will hopefully keep the snap ring from flying off. As an extra precaution, you may want to turn the tire face-down, as you've already done.
Stay safe,
Bradshaw
I'm not that far along with my truck yet, but I've heard others asking the same question.
One suggestion was to use a couple of pieces of heavy chain. Run the chain through the openings in the rim, around the tire and ring, and fasten together with a bolt. I'd use a grade 8 bolt.
These chains will hopefully keep the snap ring from flying off. As an extra precaution, you may want to turn the tire face-down, as you've already done.
Stay safe,
Bradshaw
- Neil Wilson
- Posts: 3062
- Joined: February 5th, 2003, 9:42 pm
- Body Type: 82-A/89-A
- Model Year: 1930
- Location: Boulder, CO
- Contact:
Yes, most shops will not work on split rim wheels. My process for mounting a new tire is about the same. I make sure that the slot for the removable flange is completly free of any rust built up (in addition to the removable flange. After about 20 lbs. of pressure in the new tube, I turn the wheel over and use a block of hard wood and a heavy hammer to set the removable flange in tight.
Regards, Neil Wilson
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/
Split rim wheels
I had a flat on my AA as I was driving. The split ring flew off - I never found it - but it could have gone through some one's windshield.
Any ideas on this aspect of the problem?
I'd like to find other wheels to use for driving - any ideas on that?
Thanks very much.
Vicky
Any ideas on this aspect of the problem?
I'd like to find other wheels to use for driving - any ideas on that?
Thanks very much.
Vicky
- Neil Wilson
- Posts: 3062
- Joined: February 5th, 2003, 9:42 pm
- Body Type: 82-A/89-A
- Model Year: 1930
- Location: Boulder, CO
- Contact:
If the tire went flat first, followed by the ring coming off, then it may have just gone to the side of the road. If the ring came off due to presure, then it could have traveled a considerable distance and with lots of force.
I don't know of any rings currently for sale.
I don't know of any rings currently for sale.
Regards, Neil Wilson
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/