Rear Hub Bolt

Vicky · Post by **Vicky** » August 24th, 2006, 4:55 pm

Hi -

I need to get rear hub bolts.

My rear hub bolt AA-1118 / 1119 measures 3 9/16 inches. The Parts Price List says nothing about length.

The Service Bulletins says (Feb 1930 page 418) that they changed from CR at 3 1/8 inches to E at 3 27/32 inches.

Snyders has 3 15/16inches and 3 7/32 inches

Brattons has 3 1/4

Anyone have any ideas what I should do?

Thanks a lot.

Vicky

Mike in Maine · Post by **Mike in Maine** » August 26th, 2006, 6:05 am

Vicky,
Is this the hub bolt you are talking about? Not experienced enough to give a precise answer. Is your rear axle set up for single or dual wheels? The stud pictured is on a dual wheel axle? The variation of size may be the none threaded part which would suggest a thinner hub flange. just a thought.
Mike

Vicky · Post by **Vicky** » August 27th, 2006, 6:03 pm

Hi -

Here's my stud.

I do have dual rear wheels.

What happened was the left rear drum was home to a mouse or 200 (I was missing a stud) and the amount of rust is amazing - must be from the urine. Anyhow, I can probably repair these -I have thread files. For the one that is missing, it looks as if I can modify a 3 3/4" one.

Vicky

Bob C · Post by **Bob C** » August 28th, 2006, 1:08 pm

Vicky
I think you need Budd #13988 RH and #13989 LH
Bob

Bob C · Post by **Bob C** » August 28th, 2006, 1:49 pm

Vicky,

NAPA numbers are BK 6411230 RH and BK 6411231 LH

Bob

Vicky · Post by **Vicky** » August 28th, 2006, 3:12 pm

Thanks very much, Bob.

Vicky