Quite a while back I asked for ideas on clutch repair. I had at least 3 gents tell me pulling the
engine was the better option.
Today I got under the truck. I see 4 bolts on the spring bosses, 4 cotter pins on the brake rods,
speedo connection, brake lite connection and a total of 8 bolts at the universal housing on the frame cross member. At this point I would hope the entire rear axle and & torque tube assemly would roll backward.
What am I missing that would make pulling the engine a better option??
Thanks
Stuffer
Clutch Repair
- stufferdarwin
- Posts: 52
- Joined: May 16th, 2011, 11:34 am
- Body Type: ?? closed cab
- Model Year: 1931
-
- Posts: 1442
- Joined: April 24th, 2003, 11:50 am
- Body Type: Mail truck, Stake tr
- Model Year: 1931
- Location: SO CAL
Re: Clutch Repair
If you are lucky and have the service replacement coupling shaft with the u-joint at
the back of the transmission you can just take it out and remove the transmission.
Bob
the back of the transmission you can just take it out and remove the transmission.
Bob
- Attachments
-
- coupling.jpg (229.46 KiB) Viewed 3059 times
- Chris Haynes
- Posts: 2203
- Joined: September 7th, 2003, 5:18 pm
- Body Type: 82A
- Model Year: 1930
- Location: Camarillo, CA
Re: Clutch Repair
The fun part is putting it back together and getting the splines to line up.
- stufferdarwin
- Posts: 52
- Joined: May 16th, 2011, 11:34 am
- Body Type: ?? closed cab
- Model Year: 1931
Re: Clutch Repair
Doesn't look like anything has ever been replaced on this drive line and if it depends on "luck" I'm really screwed, so I'm not counting on the replacement shaft.
If the spline alignment is the major problem I may have that figured out. It involves 2 small floor jacks and 2 piano dollies. If I can get whole unit to move back and forth smoothly and get the tires just high enough to turn freely I should be able accomplish the alignment.
Got a couple friends to help and lots of transmission stabbing experience.
If I go the engine route I'll have to rent an engine hoist ( or use a tree) & motor stand and once I get the engine out it's going to lead to a lot of expense because I won't be able to leave well enough alone.
Guys....thanks for the info
Darwin
If the spline alignment is the major problem I may have that figured out. It involves 2 small floor jacks and 2 piano dollies. If I can get whole unit to move back and forth smoothly and get the tires just high enough to turn freely I should be able accomplish the alignment.
Got a couple friends to help and lots of transmission stabbing experience.
If I go the engine route I'll have to rent an engine hoist ( or use a tree) & motor stand and once I get the engine out it's going to lead to a lot of expense because I won't be able to leave well enough alone.
Guys....thanks for the info
Darwin
- TruckMan
- Posts: 132
- Joined: March 10th, 2009, 10:36 am
- Body Type: Garwood Dump
- Model Year: 1928
- Location: Wisconsin
Re: Clutch Repair
The engine only weighs 200 lbs. I've carried it in my arms. If you have some rope and a pulley you can do it. Now I disclaim any injuries that your attorney would blame me for, but with proper care you can get the engine out without going to extremes.
But you do what makes you comfortable.
But you do what makes you comfortable.
TruckMan