I have a June 1929 AA Dump truck. I am not sure exactly where to attach the tail light support. Where does the wire run threw? There are too many holes in the rear of the frame. What are all the holes for? Any help would be greatly appreciated.
Thanks,
Matt
AA 13473 tail light support
-
- Posts: 478
- Joined: June 3rd, 2013, 6:15 pm
- Body Type: 186-B stake
- Model Year: 1931
- Location: LHC Arizona & UP Michigan
Re: AA 13473 tail light support
Some holes in the frame may have been added later for various purposes. You would have to post a photo of them here for identification.
If you are mounting the tail light at the end of the frame, the wire to it does not go through any holes it is held to the frame rail with the same clips the A's used. Sometimes on dump trucks the tail light was moved to the upper rear of the cab, but that was generally after Sept. 1930.
If you are mounting the tail light at the end of the frame, the wire to it does not go through any holes it is held to the frame rail with the same clips the A's used. Sometimes on dump trucks the tail light was moved to the upper rear of the cab, but that was generally after Sept. 1930.