aa QUESTION

[ford31]

have a AA doodlebug picked up a motor came out of a car question is,will clutch,preasure plate flywheel and pilot bearing be same as the 31 AA

[Brady]

All should be OK. You don"t say what year, or what trans the buggy has - Differences are that the 4 speed trans clutch disc was a little larger diameter, and the truck pressure plate had stronger springs - but all should interchange, and work nicely in the buggy.

[Stakebed]

isnt the only difference is the clutch disc i maybe 1/4"-1/2" larger in diameter? for a doodlebug you wont ever notice a difference between the 2.

[macswoods]

As I think back ,the throut bearing hub is different in the 4 speed than the 3 speed. (was in my late 29 with the 4 speed ). If I'm wrong let me know
because my clutch has always been high to release. Mac....

[ford31]

sorry its 31 aa, went to set car engine,would not go,pulled motor back out,using digital calipers the shaft on the aa tranny is larger than the A

[ford31]

wonder now if model a clutch was wrong,but alignment tool worked ok,need to know what to get, confused

[Bob C]

The three speed and four speed have the same size input shaft 1 3/8".

Bob

[ford31]

will the A,and AA have same,flywheel and preasure plate or will they work in my doodlebug

[Bob C]

They both use the same flywheel and the pressure plate will work.

Bob

[1955cj-5]

You need to use the shorter AA throw-out bearing carrier and the AA bellhousing.

TObearinghub.jpg (5.61 KiB) Viewed 5032 times

P1000563.JPG (145.06 KiB) Viewed 5032 times