Its me agin about the rear SORRY
Its me agin about the rear SORRY
How far down the axle tube does the outer seal go , When I look down the tube it appears to be a small ridge a few inches before it gets to the spindle I guess you would call it Thank you again for all your replies
-
- Posts: 1442
- Joined: April 24th, 2003, 11:50 am
- Body Type: Mail truck, Stake tr
- Model Year: 1931
- Location: SO CAL
Re: Its me agin about the rear SORRY
Also if the AA is like the Model A the open side of the seal goes toward the differential .
Bob
Bob
- Neil Wilson
- Posts: 3062
- Joined: February 5th, 2003, 9:42 pm
- Body Type: 82-A/89-A
- Model Year: 1930
- Location: Boulder, CO
- Contact:
Re: Its me agin about the rear SORRY
For the worm drive axle, the axle shafts outer grease seals do fit against a ridge in the outer section of the housing. This is the same design as the A chassis. A tool is made for the A chassis to install these seals as well as the drive shaft seal in the torque tube. The AA axle shaft seals would require a larger tool. And, I am fairly sure that the AA drive shaft requires a slightly different size tool.
Regards, Neil Wilson
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/