Dual High Drive Help????? Anyone?
Posted: July 6th, 2007, 9:35 pm
Hello all,
I am in the process of restoring my Dual High drive and am having problems locating replacement bearings and also removing the largest from below one of the gears. Does any one know, first if there are any books, specs, or diagrams of the Dual high drive and second if and/or where I can find replacement bearings? They are pitted but still work so should i just re-use the original? is that ok? and how far should I take the rebuild, the gears look great, no visible wear ect, just the bearings. also, there is some surface rust on the exterior case. what is best for prep and paint. i was thinking eastwood rustconverter and Detail Grey. is that acceptable? any other suggestions?
Thank you so much for your replies!
Soundgourmet
I am in the process of restoring my Dual High drive and am having problems locating replacement bearings and also removing the largest from below one of the gears. Does any one know, first if there are any books, specs, or diagrams of the Dual high drive and second if and/or where I can find replacement bearings? They are pitted but still work so should i just re-use the original? is that ok? and how far should I take the rebuild, the gears look great, no visible wear ect, just the bearings. also, there is some surface rust on the exterior case. what is best for prep and paint. i was thinking eastwood rustconverter and Detail Grey. is that acceptable? any other suggestions?
Thank you so much for your replies!
Soundgourmet