AA Ford toe in

AA Ford Discussion Group relating to the repair and restoration of your AA Ford.
Post Reply
Moto Largo
Posts: 28
Joined: October 8th, 2017, 8:58 pm
Body Type: platform
Model Year: 1928

AA Ford toe in

Post by Moto Largo »

The specification for Ford Model A toe-in is 1/16" measured 6" above the floor. I am thinking that the AA should be little more, due to the larger diameter wheels: say 3/32". Or am I splitting hairs? What is the collective wisdom for AA toe-in? I plan to use a chalk line on the tread surface for taking the measurements, or maybe modifying an old surveyor's level rod (from a past life) for taking the measurements to the inside of the tires.
Alan in Roberts Creek
Bob C
Posts: 1442
Joined: April 24th, 2003, 11:50 am
Body Type: Mail truck, Stake tr
Model Year: 1931
Location: SO CAL

Re: AA Ford toe in

Post by Bob C »

The February 1936 Service Bulletins show 3/32" for the AA.

Bob
KimVanOrder
Posts: 753
Joined: August 11th, 2013, 4:25 pm
Body Type: 82-A Platform
Model Year: 1928
Location: Hamilton, Mich.

Re: AA Ford toe in

Post by KimVanOrder »

I thought it was at the center line of the wheel, not 6" off the floor. Hairs split.
KVO
Dec. '28 AA
Bob C
Posts: 1442
Joined: April 24th, 2003, 11:50 am
Body Type: Mail truck, Stake tr
Model Year: 1931
Location: SO CAL

Re: AA Ford toe in

Post by Bob C »

Look at the link to Marco's site, you can see the 6" chains on the toe gauge just touching the floor.
http://www.abarnyard.com/workshop/align.htm

Bob
User avatar
tiredtruckrestorer
Posts: 338
Joined: April 20th, 2003, 7:09 pm
Model Year: 1931
Location: Orwigsburg, PA

Re: AA Ford toe in

Post by tiredtruckrestorer »

My 1931 Bear alignment book shows 1/32 toe in for 1928-29 AA's and 1/32 to 3/32 for the 1930-31's. The difference in these could be caused by the different caster specs. The caster for the 28-29 AA's is 1 degree and the 30-31 AA's is 3 1/2 degrees. The size of the rear tires could also make a difference (6.00 X 20 balloon tires for dual rear wheeled compared to 32X6 high pressure for single rear wheeled trucks).

Keith
Post Reply