Page 1 of 1

Warford 28/29

Posted: December 27th, 2017, 1:55 pm
by s147881
Does anyone know if the warford rear mount is the same as the one for the high/low? Can gear off high low be installed on warford trans rear? I have a chance to purchase one for 600 without rear mount. Just looking if I have a viable solution before spending the money.

Re: Warford 28/29

Posted: December 27th, 2017, 2:13 pm
by Bob C
If you are asking about the part in the left trans in the picture with the two bolts in it, yes.
If you are asking about the bearing retainer on the back of the trans, No

Bob

Re: Warford 28/29

Posted: December 27th, 2017, 7:51 pm
by s147881
I tried to fit a high low rear mount on my last warford and it did not fit. It was close but it looked like the gear piece was at a different angle. It may have just been worn.

Re: Warford 28/29

Posted: December 28th, 2017, 5:18 am
by Neil Wilson
s147881 wrote:
December 27th, 2017, 1:55 pm
Does anyone know if the warford rear mount is the same as the one for the high/low? Can gear off high low be installed on warford trans rear? I have a chance to purchase one for 600 without rear mount. Just looking if I have a viable solution before spending the money.
Part AA-4808 is the "Coupling Shaft Housing Rear Support". This support was used for AA's with the 3-speed transmission (through about Aug. 1929). It was also used for the dual high and Warford transmissions.

Re: Warford 28/29

Posted: December 28th, 2017, 4:00 pm
by s147881
Ok thanks

Re: Warford 28/29

Posted: December 28th, 2017, 6:17 pm
by KimVanOrder
I think I have one of those in the parts box. you need it?

Re: Warford 28/29

Posted: December 28th, 2017, 6:38 pm
by s147881
Thanks but I have a couple.