How much clearance are you running on the bearings??
Bob
Rod knockin'
-
- Posts: 474
- Joined: September 24th, 2009, 3:06 pm
- Body Type: Express
- Model Year: 1928
- Location: NE Illinois
Re: Rod knockin'
Was the oil pick up tube in place on the rear main when you dropped the pan???
-
- Posts: 98
- Joined: September 14th, 2017, 5:57 pm
- Body Type: Dump
- Model Year: 1928
- Location: Pa
Re: Rod knockin'
That tube is a drain tube as I understand it, but yes, it is welded in place!flatford39 wrote: ↑September 1st, 2019, 4:36 pmWas the oil pick up tube in place on the rear main when you dropped the pan???
- 1crosscut
- Posts: 877
- Joined: December 25th, 2010, 7:22 pm
- Body Type: 82-A
- Model Year: 1929
- Location: Lincoln, NE
Re: Rod knockin'
Good Question to ask the builder and it would be good to have someone check the clearances of the new bearings before installation.
------------
Dave
Dave