Page 1 of 1
28 AA warford overdrive
Posted: June 27th, 2018, 6:34 pm
by birdacre
what ratio was used on the output shaft? were they all the same. is the shifter just engaged and disengaged? any ideas?
Re: 28 AA warford overdrive
Posted: June 28th, 2018, 8:21 am
by Bob C
Haven't done the math but a 6.6 rear axle becomes a 4.94 in forth overdrive.
The Warford shifter is used to select under, direct, over, and neutral gears.
Re: 28 AA warford overdrive
Posted: June 28th, 2018, 8:33 am
by birdacre
my rear end is 5:17 it would be neat to figure out the final drive in 4th overdrive. anyone have any ideas?
Re: 28 AA warford overdrive
Posted: June 28th, 2018, 9:18 am
by Neil Wilson
birdacre wrote: ↑June 28th, 2018, 8:33 am
my rear end is 5:17 it would be neat to figure out the final drive in 4th overdrive. anyone have any ideas?
The calculations are already done - see
http://aafords.com/aa-information/#mph
Re: 28 AA warford overdrive
Posted: June 28th, 2018, 2:59 pm
by birdacre
i had forgotten that there was a warford column. thank you, i hope you are well. kevin