Page 1 of 1
Disassembly question
Posted: October 3rd, 2018, 12:00 pm
by Deere boy
If I want to remove the underdrive from a 1928 AA, do I need to start by pulling the rear axle back, then the short drive shaft, then the underdrive? Or is there some way to remove it without taking everything behind or in front of it?
Re: Disassembly question
Posted: October 3rd, 2018, 12:39 pm
by Bob C
- $(KGrHqV,!jcE4oUFBQ2WBOUsh3i85Q~~48_3.jpg (114.54 KiB) Viewed 2997 times
Not sure what you have because the Dual High underdrive goes in place of the short coupling shaft.
Bob
Re: Disassembly question
Posted: October 3rd, 2018, 6:51 pm
by 1crosscut
Unfortunately there is no easy way to get it out. I would pull the rear end out to get at it. While you have it out it would be a good opportunity to pull the transmission and go through it. Wont get any easier.
Re: Disassembly question
Posted: October 4th, 2018, 7:34 am
by Deere boy
In looking at what I have here I now notice the frame has been extended on the truck. You have the tranny, underdrive, a shaft about 20" long and then the regular drive shaft.
