My AA is a 1930 with 1929 cab, common I here. It is currently registered in Washington. Just moved to Idaho Boise area and they require vin check.
I have pulled foot and floor wood, also looked on sides were do they stamp? Motor long gone and motor thats in it does not match vin.
Idaho requires vin check
- 1crosscut
- Posts: 877
- Joined: December 25th, 2010, 7:22 pm
- Body Type: 82-A
- Model Year: 1929
- Location: Lincoln, NE
Re: Idaho requires vin check
It will be on the top of the frame to the left of where your left foot rests while driving. Unfortunately you will need to lift the cab and splash shield to see it. If you don't have much rust you might be able to lift things just enough to make a paper and pencil rubbing to get an impression of it. Location wasn't one of Mr. Fords better ideas.
------------
Dave
Dave
-
- Posts: 1442
- Joined: April 24th, 2003, 11:50 am
- Body Type: Mail truck, Stake tr
- Model Year: 1931
- Location: SO CAL
Re: Idaho requires vin check
Here is a picture Neil posted.
Bob
Bob
-
- Posts: 753
- Joined: August 11th, 2013, 4:25 pm
- Body Type: 82-A Platform
- Model Year: 1928
- Location: Hamilton, Mich.
Re: Idaho requires vin check
My 28 has the Vin just in front of the cab. No need to lift the cab. I wire brushed and brushed and brushed until I finally got it to the point that I could read it. Then I filed it with white spray paint, let it dry then scraped off the surface leaving just what is in the 'stamp'. So try looking there before lifting the cab. You may get lucky..
KVO
Dec. '28 AA
Dec. '28 AA
- Chris Haynes
- Posts: 2203
- Joined: September 7th, 2003, 5:18 pm
- Body Type: 82A
- Model Year: 1930
- Location: Camarillo, CA
Re: Idaho requires vin check
"My AA is a 1930 with 1929 cab" All Early 1930's used the '29 type sheet metal until June '30 when the new bodies went into production.
Re: Idaho requires vin check
Still can't find numbers? Only thing I have not done is pull body bolt out. Looks like someone has looked there before body has been pried up behind bolt.
I want to remove bed are they under there to? maybe?
I want to remove bed are they under there to? maybe?
- 1crosscut
- Posts: 877
- Joined: December 25th, 2010, 7:22 pm
- Body Type: 82-A
- Model Year: 1929
- Location: Lincoln, NE
Re: Idaho requires vin check
If you find them under the bed I think that you would be the first to ever do so. I once found a second stamping of the identification numbers stamped on the inner right hand side of a Model A Coupe frame. Odds of that happening for you are unfortunately very slim. I think you will need to lift the cab and splash shield unfortunately.
------------
Dave
Dave