Distributor

AA Ford Discussion Group relating to the repair and restoration of your AA Ford.
Post Reply
Shorthaul
Posts: 322
Joined: November 15th, 2008, 8:18 am
Body Type: 186 stake
Model Year: 1931
Location: Hawthorne California

Distributor

Post by Shorthaul » August 14th, 2019, 2:03 pm

Model A distributor, there is a collar on the shaft right below the housing. It looks like it has a pin through it to hold it on the shaft. How is it removed, I tried driving it through, couldn't move it. Anyone had this problem, or have an answer.

vonheine
Posts: 76
Joined: September 30th, 2009, 8:02 pm
Body Type: none
Model Year: 1930
Location: Massachusetts

Re: Distributor

Post by vonheine » August 28th, 2019, 3:16 pm

Yes, it is a pin that you can drive out with a hammer and a drift punch. It’s a .125 diameter pin. Support the collar with two wooden popsicle sticks sitting on a bench vise with a slight gap under the pin and drive it out. Grind or file the drift punch side flush with the collar to ensure you are not fighting a mushroom on the pin. You can get a new collar and pin from any of the Model A suppliers

Post Reply