Page 1 of 1

INTERMEDIATE SHAFT GEAR BACK LASH TOLERANCE

Posted: November 11th, 2019, 4:17 am
by RFJ
Does anyone have spec on intermediate shaft gear.The amount of back lash that is acceptable. Pic of a good usable one would help.

Re: INTERMEDIATE SHAFT GEAR BACK LASH TOLERANCE

Posted: November 11th, 2019, 8:52 am
by Bob C
Is this what you are asking about? There's one on Ebay, not cheap. https://www.ebay.com/itm/1929-1930-1931 ... DX&vxp=mtr

Bob
AA4811.jpg
AA4811.jpg (161.27 KiB) Viewed 2275 times

Re: INTERMEDIATE SHAFT GEAR BACK LASH TOLERANCE

Posted: November 11th, 2019, 2:36 pm
by RFJ
Thanks Bob but what I,m looking for is the inside gear on the shaft.