Page 1 of 1
PTO and hydraulic lever
Posted: January 15th, 2020, 7:35 pm
by Matt
My truck is missing the pto and hydraulic lever, could someone please post a picture of the pto and hydraulic lever in the cab?
Thanks
Matt
Re: PTO and hydraulic lever
Posted: January 16th, 2020, 8:33 am
by Matt
Thank you that will help a lot.
Matt
Re: PTO and hydraulic lever
Posted: January 16th, 2020, 12:41 pm
by Cschaff63
Here are a couple better pics
- 5D2AA8E9-4A1E-4326-AE48-C315693B9880.jpeg (77.9 KiB) Viewed 6668 times
- 22D53108-20CA-40B5-8D04-02D4BCA14B36.jpeg (95.65 KiB) Viewed 6668 times
Re: PTO and hydraulic lever
Posted: January 20th, 2020, 7:04 pm
by stew
Our truck has a little different set-up. It is equipped with a hydraulic dump body by The Marion Steel Body Company, of Marion, Ohio.
The PTO lever pivots on a longer bolt that is also used for mounting the hand brake. The small crank shaped rod that is under the seat, goes out through the back of the cab, and operates the hydraulic valve. Turning it to one side puts the valve in the raise position, turning it the other way lowers it. Leaving it in the center position holds the box in position.
- AA truck trans.JPG (386.51 KiB) Viewed 6586 times
Re: PTO and hydraulic lever
Posted: January 20th, 2020, 7:30 pm
by Cschaff63
My dump body and pto setup are by Woods Hyd