Page 1 of 1
88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 14th, 2020, 4:46 pm
by slavalley
I have a question about two V-shaped brackets that are riveted to the bottom side of cross member #5. What are they for?
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 14th, 2020, 5:32 pm
by Bob C
They keep the spare tire in position.
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 14th, 2020, 5:51 pm
by slavalley
Thank you Bob. That makes sense. Does it touch down on the rim or the tire?
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 14th, 2020, 6:45 pm
by Neil Wilson
slavalley wrote: ↑March 14th, 2020, 4:46 pm
I have a question about two V-shaped brackets that are riveted to the bottom side of cross member #5. What are they for?
Those are wheel stops (AA-1474). The wheel presses against the stops and act as anti-rattlers. See
https://aafords.com/aa-chassis/aa-1400-carriers/#wcubuf
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 14th, 2020, 7:35 pm
by slavalley
Once again, thank you Neil!
Anyone out there have a non-bent AA-1470-B rear hing bolt and nut assembly?
Scott
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 14th, 2020, 7:51 pm
by 1crosscut
Finding a replacement will be difficult. Best to heat and straighten what you have.
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 14th, 2020, 8:10 pm
by Bob C
The bolt is not correct.
- ub-uf-rhbn-q8.jpg (117.9 KiB) Viewed 7503 times
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 21st, 2020, 1:36 pm
by slavalley
Oh no! Anyone have the swing bolt for the AA-1470-B rear hinge or dimensions so I can have one made?
Re: 88-A Platform Style-d3, Cross Member #5, V-Bracket
Posted: March 21st, 2020, 7:10 pm
by Jeff Brown
I just made my own using an eye bolt I got from McMaster-Carr. Welded the stop on it and turned it down, rusted it and it was good to go!
- 20200208_110014e.jpg (617.46 KiB) Viewed 7326 times
Jeff