Page 2 of 2
Re: U joint
Posted: October 27th, 2020, 5:42 am
by Neil Wilson
Neil Wilson wrote: ↑October 26th, 2020, 6:47 am
Lvovich wrote: ↑October 26th, 2020, 1:39 am
Neil I have a normal resolution file for you (3228x2165)
But I can't attach it to the post.
Lvovich, Please email your 3228x2165 image to me at
neil@aafords.com. I can then zoom in on my computer much easier. Thanks in advance.
This AA-Fords.com site restricts image sizes.
Thanks to Lvovich, he sent me a high resolution of the AA-4802-B coupling shaft installation (stock for behind a 4-speed). I made two crops to show the front and rear. This allows posting on this site. FYI - I have no way of translating Russian to English
Re: U joint
Posted: October 27th, 2020, 5:48 am
by Neil Wilson
rsierk wrote: ↑October 25th, 2020, 10:06 pm
Looks like a GAZ drawing. Wouldn't there be a Dearborn equivalent?
rsierk, Yes there are US Ford drawings that can be ordered from the Benson Research Center. Drawings are $35 each the last time I checked.
Re: U joint
Posted: October 27th, 2020, 12:53 pm
by Shorthaul
Bob C thanks for the 7084 number. This kit is rebuild kit 28-48 part #64-24277/7084
It’s the correct part. It’s a different configuration than the stock. The center of the spider is round rather than square.
Re: U joint
Posted: October 27th, 2020, 6:48 pm
by Bob C
Before you get to far into rebuilding the u-joint I would take some measurements. To me it looks like
the AA-7084 cross is about .100" narrower than the A-7084 cross. Also the AA-7084 bushing OD looks larger
than the A-7084 bushing.
Re: U joint
Posted: October 28th, 2020, 1:23 pm
by Shorthaul
Bob,
You are correct. I Had just sort of eye balled them. The bushings are about .030 on the OD. Thanks for taking the time to mention that. Any suggestions on replacement.