Hello,
Looking at a 1928 AA doodle bug for fun. It has AA front wire wheels that I like and it's in far better condition and more complete than most doodle bugs. I would just enjoy it and tinker with for a while but there is another fella who has a 28/29 bevel gear AA rear axle with wire wheels. Minimum I would like to get the wheels. What can you tell me about the 28/29 bevel gear rear axles, are there any replacement parts for them? Doesn't appear to have the emergency brakes, how hard would it be to retrofit a set? Are there any high speed bevel gear sets?? I might be tempted in the future to return it to kind of original length.
Thanks for the help.
1928 and 1929 bevel gear rear axles
-
- Posts: 1
- Joined: February 5th, 2022, 7:24 am
- Body Type: doodle bug
- Model Year: 1928
-
- Posts: 603
- Joined: May 15th, 2010, 2:34 pm
- Body Type: dump
- Model Year: 1930
- Location: Eastern, CT
Re: 1928 and 1929 bevel gear rear axles
oldnrusty1,
Are you referring to the bevel gear that looks like a car rear end, just much larger and heavier? If so, I don't believe there are much of any parts that switch over to the 30-31 bevel rear axle, but could be mistaken. Those rear axles are quite uncommon, if not rare, especially when they are complete. There is one at my parents house, but it is missing the torque tube, driveshaft and radius rods. Pictures are always good.
Red
Are you referring to the bevel gear that looks like a car rear end, just much larger and heavier? If so, I don't believe there are much of any parts that switch over to the 30-31 bevel rear axle, but could be mistaken. Those rear axles are quite uncommon, if not rare, especially when they are complete. There is one at my parents house, but it is missing the torque tube, driveshaft and radius rods. Pictures are always good.
Red
- tiredtruckrestorer
- Posts: 338
- Joined: April 20th, 2003, 7:09 pm
- Model Year: 1931
- Location: Orwigsburg, PA
Re: 1928 and 1929 bevel gear rear axles
The early AA bevel gear is completely different than the later '30-'31 type. No parts will interchange. These rears were made like the smaller "A" rears (only in a larger version) and were available in a low speed (stamped with an "A" for the low speed version or a "B" for the high speed one) on top of the center section where the torque tube bolts to it. I was able to find all the bearings and all the races except one online from various vendors. It does use the '30-'32 radius rods and wheel bearings though. It is much heavier (weight wise) than the other "AA" rears too. Just finished rebuilding one for my current project.
Keith
Keith