driveshaft, wormshaft splines
Posted: August 23rd, 2023, 1:25 am
Dear AA-ers,
I'm from over seas, The Netherlands so excuse for any bad English..
Have a question about worn splines on my shafts (drive shaft, wormshaft and coupling ) which I like to repair.
I have a late 28 early 29 truck in restoration. The shafts are 38mm 1,496 inch round and have 10 splines/ grooves round.
Is there a technical drawing from the type of splines used on this shaft and where to find it? I need this for finding the right cutter.
Advise or tips on this item appreciated.
Pietr
I'm from over seas, The Netherlands so excuse for any bad English..
Have a question about worn splines on my shafts (drive shaft, wormshaft and coupling ) which I like to repair.
I have a late 28 early 29 truck in restoration. The shafts are 38mm 1,496 inch round and have 10 splines/ grooves round.
Is there a technical drawing from the type of splines used on this shaft and where to find it? I need this for finding the right cutter.
Advise or tips on this item appreciated.
Pietr