Page 1 of 1
Wanted - '30/'31 Driven Speedometer Gear - 5.14:1 ratio
Posted: August 24th, 2011, 6:17 am
by Neil Wilson
A Ford Model AA Truck Club member is looking for the above subject gear. It is the one which goes on the drive shaft. He does not have Internet access.
If you have the gear to sell, please email me and I will provide you his contact information.
If you have the corresponding driven gear, he needs that also. But, this gear is currently reproduced and he can buy it. Keith, do you have these for sale and how much?
Re: Wanted - '30/'31 Driven Speedometer Gear - 5.14:1 ratio
Posted: August 31st, 2011, 3:41 am
by tiredtruckrestorer
I have the AA-17271-H (5.14 ratio) driven gear available new for $60.00 plus $5.20 priority shipping.
Keith Ernst
Tired Truck Restoration
25 Springhouse Lane
Orwigsburg, PA 17961
tiredtruck@verizon.net
Re: Wanted - '30/'31 Driven Speedometer Gear - 5.14:1 ratio
Posted: August 31st, 2011, 9:58 am
by Neil Wilson
Keith,
Thanks for the information. I called Larry and found out that he just ordered the driven gear from Snyders. Their gear uses the speedometer cable end with a key. Larry's cable has a square end. So, Larry had to also order a cable and it is on back order.
I suggested that he call you. If your gear accepts the square speedometer cable end, then he would be better off returning the Snyder gear and getting one from you.
Re: Wanted - '30/'31 Driven Speedometer Gear - 5.14:1 ratio
Posted: April 6th, 2020, 3:20 pm
by 34fordbb
Any of these driven gears still available
Re: Wanted - '30/'31 Driven Speedometer Gear - 5.14:1 ratio
Posted: April 8th, 2020, 7:14 pm
by Bob C
Re: Wanted - '30/'31 Driven Speedometer Gear - 5.14:1 ratio
Posted: May 5th, 2020, 4:33 pm
by Post hole digger
Snyders zeroed out, they said there were two sets showing in inventory but they weren't on the shelf. Let me know if you find some, I will do the same for you!