Wanted: Coupling Shaft Parts

Vicky · Post by **Vicky** » May 7th, 2006, 5:38 am

Hi -

I need the following coupling shaft parts for a 1930 AA truck.

AA- 4811 Coupling shaft male gear
AA- 7095 Coupling shaft male gear retainer
AA- 4826 Coupling shaft male gear screw
A-22245 3/8 (.401-.411 3/32 x 21/32) male gear lock washer
AA- 4822 Coupling shaft thrust spring
AA- 7090-B Universal joint assembly – with collar – with bevel gear axle

My zip code is 05048 - Hartland, VT. My e-mail is vdizerega@hotmail.com

Thank you.

Vicky · Post by **Vicky** » May 7th, 2006, 6:54 am

Hi -

I forgot to say my truck is the 131 inch wheelbase.

And I also need the coupler shaft itself - the spline is too worn on the tranny end.

Thanks.

Vicky

Neil Wilson · Post by **Neil Wilson** » May 7th, 2006, 7:44 am

Vicky,
I have a '30/'31 SWB coupling shaft to sell. Send me an e-mail and I will take pictures of it for you.

Mike in Maine · Post by **Mike in Maine** » May 7th, 2006, 5:29 pm

Vicky,
Below is the best of what I have. The screw is one I had made. The spring is not original. All else is original and has some wear. Let me know if you may be interested in all or some of it. Neil may have some with more meat on the teeth. e-mail: mbtowne@adelphia.net
Mike

Neil Wilson · Post by **Neil Wilson** » May 7th, 2006, 6:03 pm

Mike,
Do you have any specifications for the spring you have. I put my truck back together with an original spring but did not take information off of it.

Mike in Maine · Post by **Mike in Maine** » May 7th, 2006, 6:08 pm

Neil,
I have it written down the measurements. Now all I have to do is find it.
The specs I have are from an original spring. I'll send it out as soon as I find it.
Mike

Mike in Maine · Post by **Mike in Maine** » May 7th, 2006, 6:59 pm

Neil,
The measurements I found are the following.
Lentgh - 1.5 inches
Wire - .090 inches (13 gauge?)
O.D. - .920 inches
I.D. - .740 inches
# coils - 6

I can only assume that the measurements are from origanal springs. I had measuremnts of two springs. One was from my truck which had a slight bend. The other was from a shaft I found with the spring still stuck
in the hole and in very good shape.
The spring I have pictured in the earlier post is not original but the only one I can find that is close to the above measurements.
Regards,Mike

Neil Wilson · Post by **Neil Wilson** » May 8th, 2006, 8:12 pm

Thanks Mike,
I appreciate the information.

aa-fords.com

Wanted: Coupling Shaft Parts

Wanted: Coupling Shaft Parts

coupler shaft

coupler spring

coupler spring