Page 1 of 1

WTB split ring for 30-31 budd wheels

Posted: November 25th, 2016, 8:24 pm
by holdover
Need a couple of split rings for 30-31 Budd wheels. Need to be intact and not sprung Thanks email me directly @ tmorisco@swva.net



thanks

tony

Re: WTB split ring for 30-31 budd wheels

Posted: November 27th, 2016, 1:23 pm
by Stakebed
if their not super sprung or kinked they can be bent back to be useful again. good luck finding a non sprung one. May have been possible back when these trucks were used daily but give it 60+ years of rust good luck...

Re: WTB split ring for 30-31 budd wheels

Posted: November 28th, 2016, 7:42 am
by holdover
I know it is wishful thinking about an unsprung ring, at this point a slightly sprung one would be acceptable

Re: WTB split ring for 30-31 budd wheels

Posted: November 30th, 2016, 6:32 pm
by 30TownSedan
Tony, where are you located?

Re: WTB split ring for 30-31 budd wheels

Posted: December 4th, 2016, 7:59 pm
by holdover
30 townsedan

sent you an email, located in Copper Hill VA tmorisco@swva.net

Re: WTB split ring for 30-31 budd wheels

Posted: December 5th, 2016, 6:37 am
by 30TownSedan
Received email. Might have had something to help you out, but VA is too far away.