AA Spring Hanger Tool - SOLD

Here you can put your AA parts for sale, and wanted posts.
Post Reply
John - NNY
Posts: 119
Joined: October 1st, 2007, 6:38 pm
Model Year: 1930

AA Spring Hanger Tool - SOLD

Post by John - NNY »

I made a Spring Hanger Tool a few years back. I sold my AA project so I'm offering the tool for sale. I did not get a chance to use it.

The Spring Hanger Tool allows turning down the rear spring hanger perch without removing the perch from the frame.

The tool consists of a solid steel shaft ( 1-1/2" x 5-7/8") that screws on to the threads of the spring hanger.
The shaft has a thread size of 3/4-16 on one end for the 1928 AA’s. The other end has a thread size of 7/8-14 for the 1929-1931 AA’s. Each end is also taped for a piece of all-tread to screw into.
The outer rotating part of the Spring Hanger Tool is an aluminum billet (3-5/8" dia x 5-5/16"). It is percussion machined to match the outer diameter of the steel shaft. One end is machined to accept a standard cutting bit (not included). It is machined to accept three handles on the outside diameter (1/2" x 6" bolts included).
How it works: The steel shaft is screwed on to the spring hanger. The rotating aluminum cutter assembly slides on the steel shaft. The cutter bit is adjusted for the depth of cut. A piece of all-thread is screwed into the opposite end of the steel shaft. A length of pipe slides over the all-thread contacting the aluminum cutter assembly. A washer and nut is put on the all-thread. The aluminum cutter assembly is rotated by hand. The nut on the all-thread is tightened to advance the cutter assembly.

I'm offering it for sale for $150 including shipping in the USA. Overseas shipping is more.

John
NNY

Below are links to posts on the subject.

http://forums.aa-fords.com/viewtopic.ph ... vot#p17310

http://forums.aa-fords.com/viewtopic.ph ... ilit=pivot
Last edited by John - NNY on March 31st, 2017, 3:45 pm, edited 1 time in total.
John - NNY
Posts: 119
Joined: October 1st, 2007, 6:38 pm
Model Year: 1930

Re: AA Spring Hanger Tool

Post by John - NNY »

Pictures can be viewed at the link below. Ruler in picture is for size reference.
John
NNY

http://www.ford-trucks.com/g/album/7184388
User avatar
Chris Haynes
Posts: 2203
Joined: September 7th, 2003, 5:18 pm
Body Type: 82A
Model Year: 1930
Location: Camarillo, CA

Re: AA Spring Hanger Tool

Post by Chris Haynes »

Perhaps you could keep it and rent it.
J0eitall
Posts: 58
Joined: August 22nd, 2012, 2:05 am
Body Type: Rack
Model Year: 1930
Location: New Jersey

Re: AA Spring Hanger Tool

Post by J0eitall »

John I tryed to pm you but it's not working for some reason today. Interested in the hanger cutter please message me or text 347-231-9593 if it's still available
Post Reply