Wanted - Universal Joint
Posted: February 13th, 2018, 6:54 pm
Hi,
I need a universal joint to connect a Warford auxiliary transmission to my driveshaft. Thought I had one but have only got two halves and one is riveted so cannot join them. Sizes of the splines that I need are as follows:
Short End (Warford) 6 splines 1.175" and 1.055" internal diameter. Bearing size on riveted type is 0.980" diameter
Long end (driveshaft) 10 splines 1.25" and 1.085" internal diameter. Bearing bush outer diameter is 0.971"
The way I see it, I could use any of the following:
1. Complete universal with both correct spines
2. Riveted universal with correct spline for driveshaft and bearing size so I could rivet the two halves to make up the right combination
3. Newer style with correct Warford spline and bearing bush size that I could mate with my driveshaft end.
Any help appreciated!
Thanks
Jeff
I need a universal joint to connect a Warford auxiliary transmission to my driveshaft. Thought I had one but have only got two halves and one is riveted so cannot join them. Sizes of the splines that I need are as follows:
Short End (Warford) 6 splines 1.175" and 1.055" internal diameter. Bearing size on riveted type is 0.980" diameter
Long end (driveshaft) 10 splines 1.25" and 1.085" internal diameter. Bearing bush outer diameter is 0.971"
The way I see it, I could use any of the following:
1. Complete universal with both correct spines
2. Riveted universal with correct spline for driveshaft and bearing size so I could rivet the two halves to make up the right combination
3. Newer style with correct Warford spline and bearing bush size that I could mate with my driveshaft end.
Any help appreciated!
Thanks
Jeff