Page 1 of 1
WANTED 88-A Stakes (AA-88220)
Posted: March 9th, 2020, 7:49 pm
by slavalley
Looking for a full set (16) of AA-88220 stakes. Bonus, if 1 of the 15 had the locking assembly (AA-88233).
Re: WANTED 88-A Stakes (AA-88220)
Posted: March 10th, 2020, 6:04 am
by Neil Wilson
slavalley wrote: ↑March 9th, 2020, 7:49 pm
Looking for a full set (16) of AA-88220 stakes. Bonus, if 1 of the 15 had the locking assembly (AA-88233).
slavalley, You show that your have a 187-A platform. Are you sure that you want the stakes for 188-A racks?
Re: WANTED 88-A Stakes (AA-88220)
Posted: March 10th, 2020, 8:30 pm
by slavalley
Yes, at the time I setup my account I wasn't sure what truck I had
I now know, I have a 88-A platform truck with 188-A stake racks .
Thanks for verifying. This has been a learning process.
Scott
Re: WANTED 88-A Stakes (AA-88220)
Posted: April 23rd, 2020, 7:02 pm
by slavalley
Anyone have measurements, or even better, a drawing so I can have some stakes made? The ones sold by Synders do not fit the 88-A
Re: WANTED 88-A Stakes (AA-88220)
Posted: April 25th, 2020, 10:03 am
by Neil Wilson
slavalley wrote: ↑April 23rd, 2020, 7:02 pm
Anyone have measurements, or even better, a drawing so I can have some stakes made? The ones sold by Synders do not fit the 88-A
slavalley, To have a shop make stakes from a drawing would require an engineering drawing. Refer to
http://www.maffi.org/WSContent/Parts.html and enter a part# of 88220 to see the drawings available. There is also one locking stake. The parts list shown this as AA-88233.
It would be best if you could buy one original from someone and then have a shop duplicate it.
There is a drawing at
https://aafords.com/open-bodies/platfor ... ipment/#ed. My drawings are for illustration and very accurate. However, they are not intended for manufacturing.