aa-fords.com

If you are interested in the following, then email me at neil@aafords.com.

I am thinking about another run to produce the installation hardware for the 89-A express. There will be three different sets (A, B and C). Each set is for a particular AA truck and 89-A express design. Each set will be $600 to $700 (yet to be determined). The set information is below:

Set-A for hardware versions 1,2,3 - 16 floor tie straps and 8 bars
Set-B for hardware version 4 - 12 floor tie straps, 6 bars, and 2 body-to-frame brackets
Set-C for hardware version 5 - 12 floor tie straps, 6 bars, and 2 body-to-frame brackets

For information about hardware versions 1-5 see https://aafords.com/open-bodies/express ... ails/#ihvt.

A set will need to be paid for up-front since I will not be producing an inventory to sell. It will likely take two years to finish the run and have sets shipped.

So i guess i will be needing set C !

gad62 wrote: ↑

September 13th, 2020, 2:42 pm

So i guess i will be needing set C !

If "gad62" is actually Greg Denney, then I got your email. Otherwise, gad62, please send me an email at neil@aafords.com

That would be me Neil.....thank you.....Greg

If you are interested in this installation hardware, email me - neil@aafords.com (note - Russ Smith and Greg Denney are on my customer list).

I am getting closer to starting another run of the 89-A Express installation hardware. It is planned that hardware sets will include the following:

floor tie straps (12 straps - 16 straps for early 1928)
bars (6 or 8 for early 1928)
"L" brackets (2 or none for early 1928)
bolts (12 or 16 for early 1928)
plates (6 or 8 for early 1928)

Attached is an example of a set for mid 1928 through mid 1929. Note that the 1/2-13 (1/2 x 7/8) hex nuts will not be included. Nuts can be ordered by each customer from other suppliers such as McMaster-Carr (see https://www.mcmaster.com/95045A033/).