Page 1 of 1

The 3 changes in the FORD 'A' engine "28-31

Posted: August 6th, 2016, 9:18 pm
by SHELBY MESSER
DSCN0925.JPG
DSCN0925.JPG (136.95 KiB) Viewed 39395 times
I use to know what the 3 changes that were made in the model 'A' engine. The only one I think I remember is a change in the rear main bearing oil flow. That may not be it. I don't want to stir any one wrong. But to the best of my knowledge there were 3 major changes. Anyone have any info on this. If you plan to build an engine this my be helpful to know. I have an early '31 engine I'm planning to build and put in my late '31. Talk about these new ' A' engines, They haven't proven themselfs yet. This engine has proven it's 85 yrs.and still running (well I pulled it from the original car(e'31 coupe) that I posted picture earlier. I'll have to do a major-major rebuild. It would run but not that great. I sold him a factory I had for $500. The I had with this fac. rb. was some times it would start right up. Other times I would run down the battery, and hand crank maybe 1/2 hr. before it would crank( the last time was in front of a local FORD dealer show room.) I had a good '30 engine engine that would in the first or second turn every time. Using the same carb. and distr. Something to read and enjoy :) Shelby, Sacramento.

Re: The 3 changes in the FORD 'A' engine "28-31

Posted: August 10th, 2016, 10:34 am
by Hayslip
The early engine had 5 camshaft bearings later reduced to 3.

Re: The 3 changes in the FORD 'A' engine "28-31

Posted: August 13th, 2016, 7:26 pm
by Brady
Later blocks were drilled with oil access hole to the rear camshaft bearing

Re: The 3 changes in the FORD 'A' engine "28-31

Posted: August 16th, 2016, 9:50 pm
by ModelAkid
Later blocks had more stiffeners or braces cast in the block above the rear main.
Another difference is another hole for water circulation was added in the middle, with the head changed to match.
Also - this is not blocks - but there are 4 or 5 different types of oil pans.

Re: The 3 changes in the FORD 'A' engine "28-31

Posted: September 26th, 2016, 7:36 am
by Stakebed
didnt the rear main cap drain pipe change diameters too?