I am looking for rear inner axle seals for my 1929 AA fire truck. all the vendors I have contacted say there source has "dreid up". These are the seals that go inside the axle housing on a worm drive rear end.
Also any sugestions on how to install them would be helpfull.
Rear axle seals for my 29 AA
-
- Posts: 6
- Joined: May 27th, 2008, 6:25 am
- Model Year: 1930
- Neil Wilson
- Posts: 3062
- Joined: February 5th, 2003, 9:42 pm
- Body Type: 82-A/89-A
- Model Year: 1930
- Location: Boulder, CO
- Contact:
Re: Rear axle seals for my 29 AA
Try Bert's Model A Center in Denver if you have not already done so (800-321-1931).
It would be of interest to have information regarding the installation if anyone has some. I would guess that it is the same procedure as for the A?
It would be of interest to have information regarding the installation if anyone has some. I would guess that it is the same procedure as for the A?
Regards, Neil Wilson
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/
______________________________________
aafords.com@gmail.com - use this email for contact
https://aafords.com/
-
- Posts: 1442
- Joined: April 24th, 2003, 11:50 am
- Body Type: Mail truck, Stake tr
- Model Year: 1931
- Location: SO CAL
Re: Rear axle seals for my 29 AA
John,
If it is part number AA4245-AR you are looking for it crosses over to a
National 450066 seal. ID 1.625, OD 2.441, W .468
If it is part number AA4245-AR you are looking for it crosses over to a
National 450066 seal. ID 1.625, OD 2.441, W .468
-
- Posts: 6
- Joined: May 27th, 2008, 6:25 am
- Model Year: 1930
Re: Rear axle seals for my 29 AA
Thanks so much. I will look for a National seal.
Re: Rear axle seals for my 29 AA
Hopefully this works to send along these pictures of a tool I made to install the rear axle seals in a '29 AA rear axle. I am working on restoring this truck and needed to get the seals in. Hunting around the shop, I found these bearing parts and a little grinding and cutting and they worked fine for putting in the two seals. These are the seals inside the tube of the worm drive rear end. I used NAPA # 16117 seals. The outside race drives in the seal and the inside race holds the parts together. What I used to drive them in was my cam bearing driver tool. In a half hour I had them both in. E-Mail me if you would be interested in using it and we can make some arrangements. Thanks
- Attachments
-
- P1010108.JPG (61.35 KiB) Viewed 4257 times
-
- P1010107.JPG (51.23 KiB) Viewed 4257 times